4-8 General Instructions for Start-Up ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Downloading the Firmware
The firmware is already included in a new unit when it is delivered. The
firmware version which the unit contains can be read sequentially via
Status Message 19. If the unit contains the wrong firmware version, the
correct firmware can be downloaded using DOLFI software.
Once a new firmware version has been downloaded, the H1 display will
indicate
PL the next time the control voltage is turned on. The basic
parameter load is activated by pressing the "S1" key.
To Next Page
Loading...
