Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - Page 282

9-70 Parameters ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Tasks 2 & 3 AA00
Manual Vector AA01
Interrupt Vector AA02
Reserved AA03
Override AA04
Open Feed Roll I AA05
Open Feed Roll II AA06
Measuring Wheel Mode AA07
Various Functions AA08
Feed-To-Length Monitoring AA09
Setup Mode AA10
Tool Wear AA11
Press: Signal Offset AA12
Press: Signal, Intermittent AA13
Signal Control: Enable AA14
Signal Control: Bit 1 AA15
Signal Control: Bit 2 AA16
Signal Control: Bit 3 AA17
Signal Control: Bit 4 AA18
Press: Time Monitoring AA19
Display B000
Serial Interface Parameter 1 B001
Serial Interface Parameter 2 B002
Analog Output 1, Signal Select B003
Analog Output 1, Expanded Signal Select B004
Analog Output 1, Scaling per 10V Full Scale B005
Analog Output 2, Signal Select B006
Analog Output 2, Expanded Signal Select B007
Analog Output 2, Scaling per 10V Full Scale B008
Serial I/O Control for BTV04 B009
System Control B010
Fieldbus Cycle Time B011
Fieldbus Baudrate B012
Fieldbus Format B013
EMD Configuration B014