Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - Page 452

15-10 EMD Module (EcoX-Bus) ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
eb0008f1_AE.WMF
Fig. 15-9: Installing the Base Module
Removing the base module requires a 6 mm x 1 mm screwdriver.
Remove the base module by placing the tip of the screwdriver on the
release clip of the base module. Proceed as shown in the following
drawing.
eb0009f1_AE.WMF
Fig. 15-10: Removing the Base Module
Removing the Base Module