Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - Page 473

ECODRIVE03-FL*-04VRS Index 17-3
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Splicing Protection 15-12
Connector X3 13-2
Continuous current limit active 12-25
Continuous current limit prewarning 12-26
Control and power sections ready for operation 12-45
Control signal bit 1 fault 12-55
Control signal bit 1 invalid 12-65
Control signal bit 2 fault 12-56
Control signal bit 2 invalid 12-65
Control signal bit 3 fault 12-56
Control signal bit 3 invalid 12-66
Control signal bit 4 fault 12-56
Control signal bit 4 invalid 12-66
COU 6-28
CPJ 6-30
CPL 6-31
CPS 6-31
Criteria for triggering the monitor 8-47
CST 6-32
CSY 6-33
Current Controller
Setting the Current Controller 8-42
Current measurement trim wrong 12-12
CVT 6-33
D
Data loss parameter 12-57
Data Storage 4-2
Deactivation of the Position Control Loop Monitor 8-49
Default parameter load 12-42
Default parameters invalid 12-41
Default parameters not available 12-41
Definition of the Critical Proportional Gain and Smoothing Time Constant 8-43
Designation I/Q/M 10-1
Determining the Critical Integral Action Time 8-43
Determining the critical position loop gain 8-47
Determining the Position Loop Setting 8-48
Determining the Velocity Loop Setting 8-43
device data sheet 11-2
Diagnostic Channel 11-6
Diagnostic Display
Watchdog (2 Dots) 12-47
Diagnostic LED for Parallel Interface 11-1
Diagnostic LED for Profibus 11-17
Diagnostic message
Composition of the diagnostic message 4-9
Diagnostic message number 4-10
Diagnostic Message Display
-0 12-47
-1 12-47
-2 12-47
-3 12-47
-4 12-47
-5 12-47
-6 12-47
E1 12-48
E2 12-48
E3 12-48
E4 12-48
E5 12-48
Diagnostic Message Priority Diagram 12-3
Diagnostic Messages in Measuring Wheel Mode 8-3
Diagnostics
Logic Task controlled 8-63
Displays
definition and error-clearing 15-21
Distance home switch – reference mark erroneous 12-40
DOLFI 4-11
DOLFI Cannot Establish a Connection 4-18
DOLFI Cannot Open the *.ibf File 4-18