Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - Page 481

ECODRIVE03-FL*-04VRS Index 17-11
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
V016 _Feed length of the IDS1.1-2_ 6-8
V017 _Feed length of the IDS1.1-3_ 6-8
V018 _Velocity of the IDS1.1-x_ 6-8
V019 _Hour Counter_ 6-8
V020 _Hour Counter, Automatic Mode_ 6-9
V021 _Actual Position Value 2_ 6-9
V022 _Actual Position Value, SSI Encoder_ 6-9
V023 _Actual Position Value Master Encoder Cam_ 6-9
V024 _Actual Velocity of the optional encoder_ 6-9
V027 _Actual Velocity of the SSI encoder_ 6-9
V028 _Length Counter for the optional encoder_ 6-9
V030 _Time Measurement Counter 1, current value_ 6-9
V031 _Time Measurement Counter 1, buffered measured value_ 6-9
V032 _Time Measurement Counter 2, current value_ 6-9
V033 _Time Measurement Counter 2, buffered measured value_ 6-9
V034 _Length Measurement Encoder 1, current value_ 6-9
V035 _Length Measurement Encoder 1, stored measured value_ 6-10
V036 _Length Measurement Encoder 2, current value_ 6-10
V037 _Length Measurement Encoder 2, stored measured value_ 6-10
V038 _Length Measurement Encoder 3, current value_ 6-10
V039 _Length Measurement Encoder 3, stored measured value_ 6-10
V044 _Actual Position Value Virtual Encoder_ 6-10
V100 _Current position value, Motor encoder_ 6-10
V101 _Target position value _ 6-10
V103 _Position lag_ 6-10
V104 _Actual velocity_ 6-10
V105 _Processed Material Length_ 6-10
V106 _Average velocity_ 6-10
V107 _Slip in Measuring Wheel Mode_ 6-11
V108 _Target Velocity_ 6-11
V113 _Distance from home position to processing location_ 6-11
Systemcontrol Error 12-60
T
Table Value 10-31
Target position < negative position limit 12-51
Target position > positive position limit 12-51
Temperature Error Threshold 12-14
Temperature Monitoring
Motor Temperature 5-2
Test Mode 6-72
The programming of a module was terminated 4-17
Timeout during delete 4-14
Timeout in the EcoX Slave 12-14
Timeout in the EMD Module 12-13, 12-28
Timeout when programming flash memory 4-14
Tool Wear 9-24
Torque > 500% 12-52
Torque limit = 0 12-25
Torque/force data scaling error 12-35
Torque/force too small for movement 12-43
Triggering of the velocity control loop monitor 8-47
TXT 6-66
U
U
D
_output 10-6
UL 12-50
UL The motor type has changed 12-4
Undervoltage in power section 12-6, 12-31
Undervoltage in the EMD Module 12-28
Unit replacement
drive controller 15-23
electronic module 15-23
unit source file 11-2
Use See appropriate use and inappropriate use
User Interface 14-17
Display Example 14-24
Display Markers 14-20
Display Variable 14-20