If printing does not work, proceed to <Question 13>.
<Question 13> Try the following points.
Change the printing protocol to LPR.
"Basic Operations/Various Information for Windows"
Enable the LPR byte count.
"Basic Operations/Various Information for Windows"
Shorten the name of the file to be printed.
If printing does not work, proceed to <Question 19>.
<Question 14> Is NetWare or SMB set properly?
When using NetWare
"Configuring NetWare"
"Configuring the Protocol Settings"
When using SMB
"Configuring the Protocol Settings"
If you are using the DHCP server and WINS server, check if the servers are linked properly.
NetWare or SMB is set properly.
Try the following point.
Set [Network Delay Time] longer than usual.
"Specifying the Setting for Startup Waiting Time"
If printing does not work, proceed to <Question 15>.
NetWare or SMB is not set properly. Set NetWare or SMB properly.
<Question 15> Is the IP address set properly?
"Basic Operations/Various Information for Windows"
SMB printing does not support IP v. 6.
The IP address is set properly. To <Question 16>.
The IP address is not set properly.
Set the IP address properly.
"Setting the IP Address (IP v. 4)"
<Question 16> Is the port to be used selected correctly?
"Basic Operations/Various Information for Windows"
The port is selected correctly. To <Question 19>.
The port is not selected properly.
Or
The settings for NetWare or SMB are changed.
Create the appropriate port.
When using NetWare
"Network Settings for the Printer (NetWare) "
When using SMB
"Network Settings for the Printer (SMB) "
<Question 17> Is AppleTalk set properly?
"Configuring the Protocol Settings"
In particular, make sure that the zone in which the printer exists is configured properly in [Zone].
㻤㻠㻡㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
