OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page A-69
August 17, 2010
TO [1R to 5R]: To waypoints:
• Valid entries are published waypoints, VHF navaids, runways, and ICAO airport identifiers.
• Valid created waypoint types are: Place-Bearing-Distance (PBD), Lat/Long and Place-Bearing-Place-Bearing
(PB-PB).
• Waypoint on airway.
• Seven (7) character waypoint identifier for oceanic latitude/longitude waypoints.
RTE 1 [6L]: Access to RTE 1 1/X page
RTE 2 [6L]: Access to RTE 2 1/X page
CANCEL [6L]: Cancel the changes made to the inactive route.
ERASE [6L]: Displayed only when a route modification is in progress. Pressing ERASE (LSK 6L) will undo all
changes to the route and return to the ACT Route status.
RESTORE [6L]: Displayed (in amber) only when the route's origin is deleted in RTE 1/X page. Used to restore
the active route.
ACTIVATE [6R]: Displayed only when route is not active. Key pressed will cause the EXEC key to illuminate.
OFFSET [6R]: To initiate offset (parallel track) navigation enter lateral offset (L99.9-R99.9) and press [EXEC].
Maximum desired lateral offset distance left or right of course is 99.9 nm. Entry is allowed only in flight if the
path to the active waypoint is a track to fix leg or a Direct-To; and not part of an approach procedure; and not
terminated by an outbound leg of type Hold. Entry of 0 or performing a [CLR] key will cancel the offset. The
default OFFSET display when an offset has not been entered or after a cancellation will be R0.0. (Displayed only
when OFFSET option is configured).
CONFIRM [6R]: Confirm the changes made to the inactive route.
(SAVE?): Displayed between the CANCEL/CONFIRM prompts when the inactive route is in modification.
To Next Page
Loading...