OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
DATA ENTRY
ADVISORY
MESSAGE
DESCRIPTION ACTION
!NO ENTRY ALLOWED
Attempt to enter data into a non-entry data
field.
For example, in a SID/STAR modification of
some combinations of waypoints is not
allowed.
Select correct data field for entry.
!NO LEG PROC
ALLOWED
On RTE page, entry of procedures (holding
pattern, search patterns, fly-over) are not
allowed in TO-field.
This refers to the procedures preceded by a
“/” (“/H”, “/O”).
Enter these special procedures on the RTE
LEGS page.
!NO STEP CLB NEAR
T/D
The selected altitude is raised while the
cruise mode is active and the aircraft is
within 50 nm before the T/D.
Acknowledge message or wait until descent
mode becomes active.
!NO STEP DES NEAR
T/D
The selected altitude is lowered while the
cruise mode is active and the aircraft is
within 50 nm before the T/D.
Acknowledge message or wait until descent
mode becomes active.
!NO SUCH CO ROUTE
Route not found in custom route database. Access SELECT CO ROUTE pages to
determine correct custom route name or
manually define flight plan by entering
waypoints on RTE LEGS pages.
!NOT CONFIGURED
Element Not Configured - Illegal Entry. Advise maintenance to ensure that all
configuration pages are correctly set.
!NOT IN DATABASE
FMS could not find entered identifier in the
navigation database or custom route
database or route.
Check identifier or re-enter the desired
identifier.
!NOT IN LIBRARY
FMS could not find entered preset number
or identifier in the radio tuning library.
Verify desired preset number/identifier.
!NOT IN ROUTE
On RTA PROGRESS page, FMS could not
find the entered identifier in flight plan.
Check the identifier or verify identifier from
RTE LEGS page.
!OUT OF RANGE
Attempt to enter data having an incorrect
range for selected field. Also displayed
when inserting an along track waypoint
which would overlap an adjacent waypoint.
Enter correct data for the desired field.
!PRESET NEEDED
FIRST
The entry of +/- to increment/decrement the
active/standby preset number requires a
valid preset number already appears in the
entry field.
Enter a valid preset number explicitly. The
+/- key can be used afterwards.
!PRESET NOT IN
LIBRARY
The Preset entered was not found in the
radio tuning library.
Enter a valid Preset.
!RADIO TUNING
DISABLED
Attempt to change a radio frequency while
FMS radio tuning is inhibited.
Verify reason for radio tuning inhibit.
!RESERVED
IDENTIFIER
Attempt to create a user waypoint with one
of the following reserved identifiers: "ORIG",
"DEST", "PPOS", "###M" where # is a
number.
Enter a different identifier.
!ROUTE FULL
Attempt to enter more than 199 waypoints in
the flight plan.
Review the flight plan for possible deletions.
!ROUTE TRUNCATED
The selected custom route or arrival
procedure has been truncated to fit flight
plan capacity (199 waypoints maximum).
Review the flight plan for possible deletions
and re-select arrival path.
!RUNWAY N/A FOR SID
Runway not applicable for SID. Not applicable.
Page E-21
August 17, 2010
To Next Page
Loading...