Cardiology
10-94 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Selecting a view during acquisition
A fixed protocol is provided for scanning, based on the selected
template. The system automatically highlights the next view to
be acquired in the template matrix, as images are stored.
However, the order of scanning may be changed manually as
follows:
Manual selection
of a view during
acquisition
1. Use the Trackball to move the cursor to the cell that
represents the view to be acquired.
The selected cell in the template matrix, highlighted in red,
indicates the non-default position. When blinking, it contains
a previously stored acquisition.
2. Press Begin/Cont. to initiate scanning.
3. Scan and save the selected loop as explained in the
previous section.
After storage, the system automatically highlights the next
available view to be acquired.
Moving an acquired image
All image can be moved from one cell to another during
acquisition.
Procedure 1 1. When in the Protocol screen, press Move Images.
2. Use the Trackball to move the cursor to the desired image.
3. Press Set.
4. Use the Trackball to move the cursor to the destination cell.
5. Press Set. The image is moved from the source cell to the
destination cell.
Procedure 2 1. In the Protocol screen, use the Trackball to move the cursor
to the cell containing the image to move (source cell).
2. Press and hold down Set.
3. With the Set key still depressed, move the Trackball to the
desired cell.
4. Release the Set key. The image is moved from the source
cell to the destination cell.
If the destination cell contains an image, the images from the
source and destination cells is exchanged when moving an
acquired image.
To Next Page
Loading...
Need help?
General
