Vascular Measurements
LOGIQ 7 Basic User Manual 11-15
Direction 2392206-100 Rev. 1
Auto Vascular Calculation (continued)
During the course of an exam, the cardiac cycle may be
indicated between two yellow bars; the peak trace and the mean
trace may appear in green; calculation indicators appear on the
spectral trace as a caliper identifier (these vary, depending on
the selected calculation in the Results Window).
The right-most, most complete cycle is typically chosen to be the
selected cardiac cycle. You can select a different cardiac cycle.
To select a different cardiac cycle:
• Use the Cycle Select control to cycle to a different cardiac
cycle.
• Move through CINE memory with the Trackball until the
desired cardiac cycle is selected by the system.
NOTE: You need several good cycles in front of the new cardiac
cycle for this to be successful. Oftentimes, this is
problematic near a freeze bar.
NOTE: You need several good cycles in front of the new cardiac cycle
for this to be successful. Oftentimes, this is problematic near a
freeze bar.
To move the systole or diastole position:
• Use the Cursor Select control to move the start systole
position or the end diastole position..
To Next Page
Loading...
