GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
3 - 24 Section 3-5 - Preparing for Setup
3-6-6-1 Connect Mains Power to the Unit (cont’d)
5.) Connect the Power Cable’s female plug to the Power Inlet at the rear of the unit.
6.) Lock the plug in position with the Retaining Clamp (ACC Clamp).
7.) Verify that the Mains Power Circuit Breaker is in OFF position, if not, switch it OFF.
8.) Connect the Power Cable’s other end (male plug) to a hospital grade mains power outlet with the
proper rated voltage, and the unit is ready for Power ON/Bootup.
.
Figure 3-12 Female power plug with retaining clamp off (to the left) and on (to the right)
Figure 3-13 Mains Power Circuit Breaker is in OFF position
ACC
Clamp off
ACC
Clamp on
OFF Position
To Next Page
Loading...
