GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
8 - 100 Section 8-16 - Front Bumper Replacement Procedure
Section 8-16
Front Bumper Replacement Procedure
8-16-1 Manpower
One person, 30 minutes
8-16-2 Tools
• Phillips size 2
• Torx screwdriver T-20
8-16-3 Preparations
1.) Shut down the system, see 4-2-3 "Power Shut Down" on page 4-7.
2.) Remove Front Cover, see "Front Cover Removal Procedure" on page 8-7.
8-16-4 Front Bumper Removal Procedure
1.) Unscrew 4 Torx screws under the bumper.
2.) Lift the bumper off.
8-16-5 Front Bumper Installation Procedure
1.) Put the new bumper in position.
2.) Fasten the 4 screws firmly.
NOTE: Do NOT overtighten these screws.
3.) Install Front Cover, see "Front Cover Installation Procedure" on page 8-7.
Figure 8-97 System front and Front Bumper
Screw holes
Front Bumper
To Next Page
Loading...
