GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
3 - 44 Section 3-9 - Connectivity Setup - Software v7.x (BT’08), v6.x, v5.x and v4.x
3-9-4 Select TCP/IP Set-up Screen
1.) Press Config (F2) and log on as adm, see 4-2-4 "Log On to the System as ‘ADM’" on page 4-12.
2.) If not already selected, select Connectivity from the bottom row of “buttons” on the screen.
3.) Select the TCP/IP TAB (it is named Tcpip). The resulting screen gives you an overview of many of
the network settings for Vivid 7.
.
NOTICE
If possible, do not change the Computer Name. If you change the Computer Name, you will loose
the access to all images in the Local Archive (on the internal hard disk drive). If you must change the
Computer Name, please refer to 3-9-5 "Changing the Computer Name, AE Title and/or Port Number
(Port No.)" on page 3-45.
Figure 3-31 TCP/IP Overview screen for Vivid 7
COMPUTER NAME / AE TITLE:
FOR Vivid 7, THIS NAME IS ON THE FORM:
VIVIDX-00NNNN, WHERE “00NNNN” IS A
NUMBER (NNNN IS THE SCANNER’S SERIAL
NUMBER).
PORT NO:
DEFAULT PORT NUMBER: 104
IP SETTINGS:
IP SETTINGS AREA FOR THE Vivid 7
SCANNER.
DEFAULT SETUP:
IP-ADDRESS: 10.0.0.3
SUBNET MASK: 255.255.255.0
GATEWAY: 0.0.0.0
REMOTE ARCHIVE SETUP AREA:
IP SETTINGS AREA FOR A REMOTE
ARCHIVE.
EXAMPLE: ECHOPAC PC (ECHOPAC7).
DEFAULT SETUP:
REMOTE ARCHIVE IP-ADDR: 10.0.0.4
REMOTE ARCHIVE NAME (THE NAME OF
THE PC OR SERVER WITH THE REMOTE
ARCHIVE): ECHOPAC7-000001
DETAILED DICOM LOG:
SELECT TO TURN DETAILED DICOM LOG ON.
(IT WILL BE TURNED OFF AFTER A RESTART)
TURN ON TO TROUBLESHOOT DICOM
ISSUES.
ADVANCED SETTINGS:
USE ADVANCED SETTINGS IF YOU NEED
TO CHANGE Vivid 7’s IP SETTINGS OR
TURN DHCP ON OR OFF.
SAVE SETTINGS
SELECT SAVE SETTINGS TO
ARCHIVE ANY CHANGES YOU HAVE
DONE TO THE TCP/IP SETTINGS
SELECT MODIFY TO CHANGE
THE COMPUTER NAME
To Next Page
Loading...
