GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
3 - 52 Section 3-9 - Connectivity Setup - Software v7.x (BT’08), v6.x, v5.x and v4.x
3-9-9 DHCP Configuration
3-9-9-1 Pre-Requisite
• Software version v4.0 or higher.
NOTE: The remote connectivity for the Global Service Platform will not function if DHCP is active.
3-9-9-2 Turn DHCP ON
Follow the instructions below to configure the Vivid 7 to use DHCP
.
1.) When in the TCP/IP screen, select ADVANCED SETTINGS to display the Network and Dial-up
Connections screen, see Figure 3-45 "Network Connections" on page 3-53.
Figure 3-44 Advanced Settings
ADVANCED SETTINGS
To Next Page
Loading...
