GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8 - 83
8-11-4 AC Power Removal Procedure
1.) Disconnect Speed Control cable, Fan cable and Input Voltage cable.
2.) Remove four (4) screws holding AC Power.
3.) Turn AC Power Module to get better access and unplug the rest of the cables. Make sure each
connector and socket are properly marked, and easy to identify during installation.
Figure 8-80 AC Power Module
Fan Cable
Speed Cable
Screws
Peripheral Voltage Select
Box turned for access to cabling.
Input Voltage cable
To Next Page
Loading...
