GE Vivid 7 - Back-End Processor (BEP) Descriptions

GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
5 - 88 Section 5-4 - Back-End Processor (BEP)
5-4-6 Back-End Processor (BEP) Descriptions
5-4-6-1 BEP4 Versions Description
NOTE: Specifications mentioned about the Back-End Processor (BEP4) are minimum requirements.
The actual hardware could exceed these specifications as technology advances.
NOTE: BEP4.3 is released for the BT’08 introduction. It has a 160 GB hard disk drive and a new DVD-
R/W drive. Other specifications are the same as BEP4.2.
The EMC Enclosure House
Table 5-60 Contents in the BEP4.x EMC Enclosure House
DESCRIPTION BEP4.2
BEP4.0
USED AS
BEP2.2
REPLACEMENT
BEP4.0 AS BEP2.0
AND BEP1
REPLACEMENT
POWER SUPPLY WITH UPS BATTERY BACKUP
NO
YES YES
POWER SUPPLY WITHOUT UPS BATTERY BACKUP
YES NO
NO
MOTHERBOARD WITH 1 GBYTES OF RAM AND A
SINGLE 3.4 GHZ P4 PROCESSOR.
YES NO
NO
MOTHERBOARD WITH 1 GBYTES OF RAM AND A
SINGLE 3.4 GHZ P4 PROCESSOR DOWNCLOCKED TO
2.2 GHZ
NO
YES YES
SIX (6X) USB PORTS ON THE REAR PANEL AND ONE
(1X) LOCATED ON THE FRONT OF THE BEP4.X,
YES YES YES
ONE SERIAL (RS-232C) PORT
YES YES YES
AGP ANALOG VIDEO OUTPUT FROM THE
MOTHERBOARD
NO YES YES
ANALOG GFX VIDEO OUTPUT FROM THE
MOTHERBOARD
YES NO NO
PCIexpress DVI 4D Gfx card
(ONLY FOR 4D)
YES
N/A N/A
VIDEO FRAME GRABBER CARD
YES YES
NO
LAN OUTPUT FROM THE MOTHERBOARD (10/100/1000
BASE T)
YES YES YES