GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
8 - 104 Section 8-19 - Brake Pedal and Direction Lock Assembly Replacement Procedures
8-19-5 Brake Pedal and Direction Lock Installation Procedure
1.) Put the Brake Pedal and Direction Lock Assembly in position and fasten the 4 hexagon screws
loosely in the sliding nuts.
2.) Fasten the ball joint nuts before tightening the 4 hexagon screws.
3.) Install Front Bumper, see "Front Bumper Installation Procedure" on page 8-100.
4.) Fasten footrests to Brake Pedal and Direction Lock Assembly. Fasten the screws gently.
8-19-6 Verification - Functional Checks
• Please perform the tests specified in Section 8-20 "Verification - Functional Checks" on page 8-105.
To Next Page
Loading...
