GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 3 - System Setup 3 - 57
3-9-13 Configurable Remote Path User
It is possible to set the User and Password for all remote paths as secondary creditials. These settings
are only used if the log in with the default User and Password fails. If the log in with the default User and
Password succeed, these settings are not used.
Follow these steps to configure the Remote Path User:
1.) Press Config (F2) and log on as ADM, see 4-2-4 "Log On to the System as ‘ADM’" on page 4-12.
2.) If not already selected, select Connectivity from the bottom row of “buttons” on the screen.
3.) Select the Tools tab.
4.) Enter the Secondary User and Password in the assigned fields.
Figure 3-52 Tools screen
REMOTE PATH
CONFIGURABLE
REMOTE PATH USER
To Next Page
Loading...
