GE Vivid 7 - Introduction; Contents in this Section; Compatibility

GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 3 - System Setup 3 - 109
Section 3-11
Connectivity Setup - Software v2.x
NOTE: FMI 76037 updates software versions v2.3.0 and below to Software version v2.3.1.
NOTE: If connected as a stand-alone network, only scanner, EchoPAC PC Workstation and an optional
network printer in a separate network, you should use default delivery settings.
3-11-1 Introduction
To be able to use the network functions when connected to a hospital network, the scanner must have
a proper network address.
• Before you can set up the scanner, you need to collect some information. The "Pre-quote
Worksheet for DICOM Network Information" on page 2-14 can be used for gathering this
information. Typical source for this information is the network administrator.
• Follow the steps below to prepare the scanner for use on the network.
3-11-2 Contents in this Section
• 3-11-3 "Compatibility" on page 3-109
• 3-11-4 "Select TCP/IP Set-up Screen - Software v2.x" on page 3-110
• 3-11-5 "Set the Scanner’s Network Information - Software Version v2.x" on page 3-112
• 3-11-6 "Set the Remote Archive’s Network Information - Software v2.x" on page 3-113
• 3-11-7 "Save the New Settings - Software v2.x" on page 3-113
• 3-11-8 "Verification of a Connection Set Up to EchoPAC PC - Software v2.x" on page 3-114
• 3-11-9 "HL7 Communication Setup for Software v2.x" on page 3-122
• 3-11-10 "Set Up Connection to a DICOM Server in a Network - Software v2.x" on page 3-126
3-11-3 Compatibility
3-11-3-1 Vivid 7 with Software Version v2.4.x
Vivid 7 with Software Version v2.4.x (System Software v1.5.1) can communicate with:
• EchoPAC PC with software version v2.4.x
• EchoPAC PC with software version v3.x
• EchoPAC PC with software version v4.x
• EchoPAC PC with software version v5.x
• EchoPAC PC with software version v6.x
• EchoPAC PC with software version v7.x
• Image Vault 3
• Image Vault 4
• EchoServer 7