GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
9 - 38 Section 9-18 - Front-End Processor Card Cage
Section 9-18
Front-End Processor Card Cage
9-18-1 Introduction
Two versions of the Front-End Processor have been used;
• Front-End Processor Version 1 (FEP1), see page 9-42.
• Front-End Processor Version 2 (FEP2), see below.
9-18-2 Hardware/Software Versions, Front-End Processor Version 2 (FEP2)
This overview is valid for the following Vivid 7 models:
• BT’03-RFI: FC000410, FC000420, FC000430, FC000440
• BT’04: FC000610, FC000620, FC000630, FC000640, FC000650, FC000660, FC000699
• BT’05: FC000760, FC000770, FC000780, FC000790, FC000800, FC000810, FC000820,
FC000830, FC000840, FC000850
• BT’06:FC000890, FC000900, FC000910, FC000920, FC000930, FC000940, FC000950,
FC000960, FC000970, FC000980
• BT’08: FD000010, FD000020, FD000120, FD000130, FD000140, FD000150, FD000160,
FD000170, FD000180, FD000190
Use Table 9-30 to verify the correct/needed revision on each card in the FEP2.
Table 9-30 Required Revisions for Cards and Modules, FEP2 sheet 1 of 2
2nd VERSION OF FRONT-END CARD CAGE (FEP2)
PART
NUMBER NAME
BT’03
(SW. v3.2.x/
v3.4.x/
v3.6.x)
BT’04
(SW. v4.x)
BT’05
(SW. v5.x)
BT’06
(SW. v6.x)
BT’08
(SW. v7.x)
COMMENTS
MCD MCD MCD MCD MCD
FC200230
BACK-
PLANE
02 02 02 02 02
FB200060 RLY-3 07 07 07 07 07
RELAY BOARD VERSION 3
- MCD REV 14 Value of internal fuse increased
to solve issue that Pedof probe is not
recognized due to defective fuse.
- MCD REV 13 includes a noise fix for noise in
Color Flow that was a result of changes on
MCD rev 12.
- MCD REV 11 includes a noise-fix to avoid
noise in CW duplex with M3S probe.
- MCD REV 09 includes a noise-fix for M3S
probe- MCD REV 08 has LEDs for +5V and
+12V.
FC200314 RLY-4 N/A 02 02 02 02
RELAY BOARD VERSION 4
TO BE USED IN UNITS WITH 3D
FC200057 RX128-4 02 02 02 02 02 RECEIVER BOARD VERSION 4
To Next Page
Loading...
