GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8 - 47
8-8-11 Software Loading - Software Version v3.x
8-8-11-1 Overview
This software loading procedure covers:
• Installation of BT’03 software (software version v3.x) on Vivid 7 units.
Refer to Table 8-13 on page 8-46 where you recorded the unit’s software versions.
The software for Vivid 7 is divided on two CDs, one CD with the System Software and one with the
Application Software.
8-8-11-2 Vivid 7 System SW Loading - Software Version v3.x
1.) Insert the applicable Vivid 7 System Software CD into the CD drive.
2.) Power down the System, see 4-2-3 "Power Shut Down" on page 4-7.
3.) Wait until the LCD’s on the Operator Panel are switched off and the ON/Standby switch has turned
yellow.
4.) Power ON the System, see 4-2-3 "Power Shut Down" on page 4-7. The scanner will now boot from
the CD you inserted.
Figure 8-41 BIOS loading example
To Next Page
Loading...
