Intermec Antares 2420 - Page 10

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
x
Scanner Test 7-17
Serial Loopback Test 7-18
Defining the System Diagnostics Screens 7-19
Access Point 7-19
Application Efficiency 7-20
Malloc Application Information 7-21
Malloc Firmware Information 7-22
Serial Port Test 7-23
Subsystem Versions 7-24
Reader Command Reference
Using Reader Commands 8-3
Using Accumulate Mode 8-4
Enter Accumulate Mode 8-6
Backspace 8-6
Clear 8-6
Enter 8-7
Exit Accumulate Mode 8-7
Operating Reader Commands 8-8
Backlight On and Off 8-8
Boot Terminal 8-9
Change Configuration 8-9
Default Configuration 8-10
Multiple-Read Labels 8-10
Reset Firmware 8-11
Save Configuration in Flash Memory 8-11
Scanner Trigger On and Off 8-12
Set Time and Date 8-13
Test and Service Mode 8-13
File Management Reader Commands 8-14
Abort Program 8-14
Delete File 8-15
Receive File 8-16
Receive File Through the Serial Port 8-16
Receive File Via RF Communications 8-18
Rename File 8-20
Run Program 8-21
Transmit File 8-22
Transmit File Through the Serial Port 8-22
Transmit File Via RF Communications 8-24
8