Nugg
Co de 39
Using Custom Applications
5-11
5
b. In the TRAKKER Antares filename field, type the drive and filename on the
terminal. You can select a previously used filename from a list by clicking on the
down arrow.
You can only download applications to drive C. On the T2420, you can
download files to drive C, D (if available), E, or G (if available). On the T2425,
you can download files to drive C, D (if available), or E.
7. If you are downloading an application and want to run it on the terminal immediately
after it is downloaded, turn on the Run program check box.
Note:
You can also run the application at any time from the terminal. For help, see
“Running the Application on the Terminal” later in this chapter.
8. Click Download to copy the file from the PC to the terminal. If you turned on the
Run program check box, the terminal boots, resets, and runs the application you
downloaded. Otherwise, the current application continues to run on the terminal.
Or, click Upload to copy the file from the terminal to the PC.
9. To download or upload another file, repeat Step 5 through Step 7.
10. Click Exit to close the FileCopy utility.
If you have problems downloading or uploading applications and files, see Chapter 6,
“Troubleshooting.”
To Next Page
Loading...
