nuggetf
code39
Contents
vii
Configuring the Terminal
How to Configure the Terminal 3-3
Learning About Configuration Parameters 3-3
Choosing the Symbologies the Terminal Decodes 3-4
Specifying How the Terminal Will Communicate 3-4
Controlling How the Terminal Will Operate 3-5
Configuring the Terminal With the Menu System 3-6
Exploring the Configuration and System Menus 3-8
Selecting Menus and Commands 3-9
Filling In Fields and Marking Check Boxes 3-10
Entering ASCII Control Characters 3-11
Exiting Screens and Saving Changes 3-13
Exiting the Configuration Menu 3-13
Exiting the TRAKKER Antares 2400 Menu System 3-14
Configuring the Terminal by Scanning Bar Codes 3-15
Saving Configuration Changes in Flash Memory 3-17
Restoring the Terminal’s Default Configuration 3-19
Upgrading the Firmware 3-21
Recording Your Terminal’s Configuration 3-24
Operating the Terminal in a Network
How the TRAKKER Antares Terminal Fits Into Your Network 4-3
Using Serial Communications on the Terminals 4-10
Identifying the COM Ports 4-10
Connecting the Terminal to Another Device 4-11
Choosing a Communications Protocol 4-13
Binary Protocol 4-14
Configurable Protocol 4-14
Master Polling Protocol 4-15
Polling Mode D Protocol 4-15
Configuring the Serial Port Parameters 4-15
Configuring the Terminal Via the Serial Port 4-16
3
4
To Next Page
Loading...
