Intermec Antares 2420 - Page 85

Co de 39
Nugget
Learning How to Use the Terminal
2-25
2
To install the battery pack
1. Hold the battery pack with the flat side facing down toward the inside of the battery
compartment. The small arrow on the top of the battery pack must point toward the
top (screen) end of the terminal.
2. Place the battery pack into the upper (larger) half of the battery compartment.
242XU.082
Connector end
Connector pin
(2 places)
Slots
3. Hook the slots on the bottom of the battery pack into the slots on the bottom of the
battery compartment.
4. Slide the battery pack toward the top end of the terminal until it fits and locks into the
connectors inside the bottom case. The battery pack must be all of the way forward
to close the battery door.