EasyManuals Logo

Keysight Technologies 6811C Programming Guide

Keysight Technologies 6811C
315 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 147
Source Subsystem (Phase) Commands
This subsystem programs the output phases. When phase commands are used to
program single-phase units, the only discernible effect in using the phase
commands is to cause an instantaneous shift in the output waveform phase.
Subsystem syntax
PHASe
This command sets the phase of the output voltage waveform relative to an
internal reference. The phase angle is programmed in degrees. Positive phase
angles are used to program the leading phase, and negative phase angles are
used to program the lagging phase.
[SOURce:]
PHASe
[:ADJust|:IMMediate] <n> Sets the output phase
:AUXiliary
[:ADJust|:IMMediate] <n> Sets the output phase
:MODE <mode> Sets the phase mode (FIX | STEP | PULS | LIST)
:TRIGgered <n> Sets the triggered phase (step or pulse mode only)
Command syntax [SOURce:]PHASe[:ADJust|:IMMediate] <NRf+>
Parameters –360 through +360 (degrees) | MAXimum | MINimum
*RST value 0
Examples
PHAS 90 PHAS MAX
Query syntax [SOURce:]PHASe[:ADJust|:IMMediate]?
Returned parameters <NR3>
Related commands PHAS:MODE PHAS:TRIG

Table of Contents

Other manuals for Keysight Technologies 6811C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight Technologies 6811C and is the answer not in the manual?

Keysight Technologies 6811C Specifications

General IconGeneral
BrandKeysight Technologies
Model6811C
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals