3 Language Dictionary
198 Keysight Models 6811C, 6812C, and 6813C Programming Guide
ABORt
This command resets the measurement and transient trigger systems to the Idle
state. Any output transient or measurement that is in progress is immediately
aborted. ABORt also cancels any lists or pulses that may be in process.
ABORt also resets the WTG bit in the Operation Condition Status register (refer to
“Programming the Status Registers” on page 259 in Chapter 5, "Programming
Examples"). ABORt is executed at power turn-on and upon execution of *RCL,
RST, or any implied abort command (refer to “Source Subsystem (List)
Commands” on page 134).
TRIGger
:SEQuence2
:DEFine SYNChronize Sets or queries the SEQ2 name
:SEQuence3
:DEFine ACQuire Sets or queries the SEQ3 name
If INITiate:CONTinuous ON has been programmed, the trigger subsystem
initiates itself immediately after ABORt, thereby setting the WTG bit.
Command syntax ABORt
Parameters None
Examples
ABOR
Related commands INIT *RST *TRG TRIG
To Next Page
Loading...
Need help?
General
