Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 55
Subsystem Commands
Subsystem commands are specific to ac source functions. They can be a single
command or a group of commands. The groups comprise commands that extend
one or more levels below the root. The description of common commands follows
the description of the subsystem commands.
The subsystem command groups are listed in alphabetical order and the
commands within each subsystem are grouped alphabetically under the
subsystem. Commands followed by a question mark (?) take only the query form.
When commands take both the command and query form, this is noted in the
syntax descriptions.
You will find the subsystem command groups discussed on the following pages:
Subsystem Page
Calibration Subsystem Commands page 57
Display Subsystem Commands page 72
LXI Subsystem Commands page 74
Measurement Subsystem (Arrays) Commands page 78
Measurement Subsystem (Current) Commands page 85
Measurement Subsystem (Frequency) Commands page 90
Measurement Subsystem (Power) Commands page 92
Measurement Subsystem (TVOLt) Commands page 95
Measurement Subsystem (Voltage) Commands page 98
Output Subsystem Commands page 103
Sense Subsystem Commands page 111
Source Subsystem (Current) Commands page 117
Source Subsystem (Frequency) Commands page 123
Source Subsystem (Frequency Modulation) Commands page 127
Source Subsystem (Function) Commands page 129
Source Subsystem (List) Commands page 134
Source Subsystem (Phase) Commands page 147
To Next Page
Loading...
Need help?
General
