Keysight Technologies 6811C Programming Guide

3 Language Dictionary
148 Keysight Models 6811C, 6812C, and 6813C Programming Guide
PHASe:AUXiliary
Keysight 6812C/6813C Option 026 only
This command sets the phase of the auxiliary output voltage waveform relative to
an internal reference. The phase angle is programmed in degrees. Positive phase
angles are used to program the leading phase, and negative phase angles are
used to program the lagging phase.
PHASe:MODE
This command determines how the output phase is controlled during a triggered
output transient. The choices are as follows:
– FIXed: The output phase is unaffected by a triggered output transient.
– STEP: The output phase is programmed to the value set by PHASe:TRIGgered
when a triggered transient occurs.
– PULSe: The output phase is changed to the value set by PHASe:TRIGgered for
a duration determined by the pulse commands.
– LIST: The output phase is controlled by the phase list when a triggered
transient occurs.
Command syntax [SOURce:]PHASe:AUXiliary[:ADJust|:IMMediate] <NRf+>
Parameters –360 through +360 (degrees) | MAXimum | MINimum
*RST value 0
Examples
PHAS:AUX 90 PHAS:AUX MAX
Query syntax [SOURce:]PHASe:AUXiliary[:ADJust|:IMMediate]?
Returned parameters <NR3>
Related commands VOLT:AUX
Command syntax [SOURce:]PHASe:MODE <mode>
Parameters FIXed | STEP | PULSe | LIST
*RST value FIXed
Examples
PHAS:MODE LIST PHAS:MODE FIX
Query syntax [SOURce:]PHASe:MODE?
Returned parameters <CRD>
Related commands PHAS PHAS:TRIG

Keysight Technologies 6811C Specifications

General

Brand	Keysight Technologies
Model	6811C
Category	Measuring Instruments
Language	English