Keysight Technologies 6811C Programming Guide

Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 203
TRIGger:SEQuence2:PHASe
TRIGger:SYNChronize:PHASe
These commands set the phase angle with respect to an internal phase reference
when the TRIGger:SYNChronize:SOURce is set to PHASe. The range is from –360
to +360 degrees.
TRIGger:SEQuence3
TRIGger:ACQuire
When the trigger subsystem has been initiated, these commands generate a
measurement trigger regardless of the selected trigger source. The measurement
trigger causes the ac source to digitize the instantaneous output voltage and
current for several output cycles and store the results in a buffer.
The FETCh commands return the requested calculation from this acquired data.
When the measurement completes, the WTG bit in the Status Operation
Condition register is cleared.
Command syntax TRIGger:SEQuence2:PHASe <NRf+>
TRIGger:SYNChronize:PHASe <NRf+>
Parameters –360 to +360 (degrees) | MAXimum | MINimum
*RST value 0
Examples
TRIG:SYNC:PHAS 90 TRIG:SEQ2:PHAS 180
Query syntax TRIGger:SEQuence2:PHASe?
TRIGger:SYNChronize:PHASe?
Returned parameters <NR3>
Related commands ABOR TRIG TRIG:DEL TRIG:SYNC INIT INIT:CONT
*TRG WAI
Command syntax TRIGger:SEQuence3[:IMMediate]
TRIGger:ACQuire:[:IMMediate]
Parameters None
Examples
TRIG:ACQ TRIG:SEQ3:IMM
Related commands ABOR TRIG TRIG:DEL TRIG:SYNC TRIG:SYNC:PHAS
INIT INIT:CONT *TRG WAI

Keysight Technologies 6811C Specifications

General

Brand	Keysight Technologies
Model	6811C
Category	Measuring Instruments
Language	English