Keysight Technologies 6811C Programming Guide

Programming Examples 5
Keysight Models 6811C, 6812C, and 6813C Programming Guide 249
– By pressing the front panel Trigger key when the unit is operating in local
mode.
Continuous triggers
– By sending the following commands over the GPIB:
TRIGger:SEQuence1:SOURce IMMediate
INITiate:CONTinuous:SEQuence1 ON
When the trigger system enters the Output Change state upon receipt of a trigger
(refer to Figure 5-2), the triggered functions are set to their programmed trigger
levels. When the triggered actions are completed, the trigger system returns to
the Idle state.
Specifying a dwell time for each list point
Each voltage and current list point has an associated dwell time specified by:
LIST:DWELl <n>{, <n>}
where <n> specifies the dwell time in seconds. The number of dwell points must
equal the number of output points. If a dwell list has only one value, that value will
be applied to all points in the output list. After each new output level or point is
programmed, the output remains at that point in the list for the programmed
dwell interval before the list advances to the next point. Only an ABORt command
can transfer the system out of the Dwelling state.
At the end of the dwell interval, the transition to the next state depends on
whether or not the list has completed its sequencing and the state of the
LIST:STEP command (refer to Figure 5-2).
If the list is completed, the trigger system returns to the Idle state.
– If the list is not completed, then the system reacts as follows:
LIST:STEP ONCE
programs the trigger system to return to the Initiated
state to wait for the next trigger.
LIST:STEP AUTO
programs the trigger system to immediately execute
the next list point.

Keysight Technologies 6811C Specifications

General

Brand	Keysight Technologies
Model	6811C
Category	Measuring Instruments
Language	English