Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 215
For Keysight 6812C/6813C Option 026 only, this command sets the auxiliary
output voltage and phase to zero.
*SAV
[SOUR:]CURR:PEAK:TRIG
13 A/26 A/32 A
[b]
[SOUR:]VOLT:RANG MAX
[SOUR:]CURR:PROT:STAT OFF [SOUR:]VOLT:SENS:DET RTIM
[SOUR:]FREQ 60 Hz [SOUR:]VOLT:SENS:SOUR INT
[SOUR:]FREQ:MODE FIX [SOUR:]VOLT:SLEW INF
[SOUR:]FREQ:SLEW INF [SOUR:]VOLT:SLEW:MODE FIX
[SOUR:]FREQ:SLEW:MODE FIX [SOUR:]VOLT:SLEW:TRIG INF
[SOUR:]FREQ:SLEW:TRIG INF [SOUR:]VOLT:TRIG 0
[SOUR:]FREQ:TRIG 60 Hz TRIG:DEL 0
[SOUR:]FM OFF TRIG:SOUR BUS
[SOUR:]FM:DEV 0 TRIG:SEQ2:SOUR IMM
[SOUR:]FM:FREQ 0.1 TRIG:SEQ2:PHAS 0
[SOUR:]FUNC:MODE FIX TRIG:SEQ3:SOUR BUS
[SOUR:]FUNC:TRIG SIN
[a] This command is for Keysight 6812C/6813C Option 026 only
[b] 13 A for Keysight 6811C and 6812C; 26 A for Keysight 6813C; and 32 A for Keysight 6813C Option 019
– *RST does not clear any of the status registers or the error queue, and ac
source does not affect any interface error conditions.
– *RST does not affect the data in any of the lists.
– *RST sets the trigger system to the Idle state.
Command syntax *RST
Parameters None
Related commands *PSC *SAV
To Next Page
Loading...
Need help?
General
