Keysight Technologies 6811C Programming Guide

Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 151
PULSe:DCYCle
This command sets the duty cycle of the triggered output pulse. The duty cycle
units are specified in percent.
PULSe:HOLD
This command specifies whether the pulse width or the duty cycle is to be held
constant when the pulse period changes. The following tables describe how the
duty cycle, period, and width are affected when one, two, or all three parameters
are set in a single program message.
Command syntax [SOURce:]PULSe:DCYCle <Nrf+>
Parameters 0 to 100 (percent) | MINimum | MAXimum
*RST value 50
Examples
PULS:DCYC 75 PULS:DCYC MAX
Query syntax [SOURce:]PULSe:DCYCle?
Returned parameters <NR3>
Related commands PULS:COUN PULS:HOLD PULS:PER PULS:WIDT
Command syntax [SOURce:]PULSe:HOLD <parameter>
Parameters WIDTh | DCYCle
*RST value WIDTh
Examples
PULS:HOLD DCYC
Query syntax [SOURce:]PULSe:HOLD?
Returned parameters <CRD>
Related commands PULS:COUN PULS:DCYC PULS:PER PULS:WIDT

Keysight Technologies 6811C Specifications

General

Brand	Keysight Technologies
Model	6811C
Category	Measuring Instruments
Language	English