Keysight Technologies 6811C Programming Guide

Language Dictionary 3
Keysight Models 6811C, 6812C, and 6813C Programming Guide 207
*CLS
This command clears the following registers (refer to “Programming the Status
Registers” on page 259 in Chapter 5, "Programming Examples" for descriptions of
all registers):
– Standard Event Status
– Operation Status Event
– Questionable Status Event
– Status Byte
–Error Queue
*ESE
This command programs the Standard Event Status Enable register bits. The
programming determines which events of the Standard Event Status Event
register (refer to “*ESR?” on page 208) are allowed to set the ESB (Event Summary
Bit) of the Status Byte register. A “1” in the bit position enables the corresponding
event. All of the enabled events of the Standard Event Status Event Register are
logically ORed to cause the Event Summary Bit (ESB) of the Status Byte Register
to be set. refer to “Programming the Status Registers” on page 259 in Chapter 5,
"Programming Examples" for descriptions of the Standard Event Status registers.
The query reads the Standard Event Status Enable register.
*TST? Perform self test, then return result
*WAI Hold off bus until all device commands done
Command syntax *CLS
Parameters None

Keysight Technologies 6811C Specifications

General

Brand	Keysight Technologies
Model	6811C
Category	Measuring Instruments
Language	English