Keysight x-series User Reference Guide

12 Disturbance Analyzer Measurement
Marker
Example :CALC:DAN:MARK:AOFF
Couplings Sets the selected marker to 1.
Initial S/W Revision A.14.00
Marker X Axis Value (Remote Command Only)
Sets the marker X Axis value in the current marker X Axis Scale unit. It has no effect if the control mode is
Off, but is the SCPI equivalent of entering an X value, if the control mode is Normal or Delta.
Key Path
Marker, Select Marker
Remote Command
:CALCulate:DANalyzer:MARKer[1]|2|...|12:X <real>
:CALCulate:DANalyzer:MARKer[1]|2|...|12:X?
Example CALC:DAN:MARK3:X 0
CALC:DAN:MARK3:X?
Notes If no suffix is sent, it will use the fundamental units for the current marker X Axis Scale. If a suffix is
sent that does not match the current marker X Axis Scale unit, an “Invalid suffix” error will be
generated.
The query returns the marker’s absolute X Axis value if the control mode is Normal, or the offset from
the marker’s reference marker, if the control mode is Delta. The query is returned in the
fundamental units for the current marker X Axis scale: seconds. If the marker is off the response is
not a number (NAN).
Preset 9.91E+37
State Saved No
Initial S/W Revision A.14.00
Marker Y Axis Value ( Remote Command Only )
Returns the marker Y Axis value in the current marker Y Axis unit.
Remote Command
:CALCulate:DANalyzer:MARKer[1]|2|...|12:Y?
Example CALC:DAN:MARK11:Y?
Notes The query returns the marker Y-axis result. If the marker is Off the response is 9.91E+37
State Saved No
Initial S/W Revision A.14.00
EMI Receiver Mode Reference 1043

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)