Keysight x-series User Reference Guide

4 Input/Output Functions
Input/Output
Antenna Unit
For devices (like antennas) that make measurements of field strength or flux density, the correction array
should contain within its values the appropriate conversion factors such that, when the data on the
analyzer is presented indBµV, the display is calibrated in the appropriate units. The "Antenna Unit" used
for the conversion is contained within the corrections array database. It may be specifiedor loaded in from
an external file or SCPI.
When an array with an Antenna Unit other than "None" is turned on, the Y Axis Unit of the analyzer is forced
to that unit. When this array is turned on, and it contains an Antenna Unit other than “None”, the Y Axis
Unit of the analyzer is forced to that Antenna Unit., and all other Y Axis Unit choices are grayed out.
Antenna Unit does not appear in all Modes that support Corrections. Only the modes listed in the Mode
row of the table below support Antenna Units.
Key Path
Input/Output, Corrections, Properties
Mode SA, I/Q Analyzer, Phase Noise, VXA, RTSA, EMI Receiver, DVB-T/H, DTMB, DVB-T/H, DTMB, W-
CDMA, LTE & LTE-Adv FDD, LTE & LTE-Adv TDD, Sequence Analyzer, BTooth
Remote Command
[:SENSe]:CORRection:CSET[1]:ANTenna[:UNIT] GAUSs | PTESla | UVM | UAM |
UA | NOConversion
[:SENSe]:CORRection:CSET[1]:ANTenna[:UNIT]?
Example CORR:CSET:ANT GAUS
Dependencies Only the first correction array (Correction 1) supports antenna units.
Note that this means that a correction file with an Antenna Unit can only be loaded into the
Corrections 1 register. Consequently only for Correction 1 does the dropdown in the Recall dialog
include.ant, and if an attempt is made to load a correction file into any other Correction register
which DOES contain an antenna unit, a Mass Storage error is generated.
Preset Unaffected by Preset. Set to NOC by Restore Input/Output Defaults
State Saved Saved in instrument state
Initial S/W Revision A.02.00
Modified at S/W Revision x.14.50
None
Selects no antenna unit for this Correction set. Thus no Y Axis unit will be forced.
Key Path
Input/Output, Corrections, Properties, Antenna Unit
Example :CORR:CSET:ANT NOC
Readback "None"
Initial S/W Revision A.02.00
dBµV/m
Sets the antenna unit todBµV/m. If this correction is turned on, and Apply Corrections is on, the Y Axis Unit
will then be forced todBµV/m and all other Y Axis Unit selections will be grayed out.
186 EMI Receiver Mode Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)