Keysight x-series User Reference Guide

10 Monitor Spectrum Measurement
Meas Setup
Couplings When the signal list is cleared, this value will reset to 0.
Preset If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
State Saved Saved in instrument state
Min 0
Max Number of peaks in the signal list table.
Initial S/W Revision A.13.00
Navigate
This menu enables you to navigate through the signal list without using a mouse.
Key Path
Meas Setup, Signal List
Initial S/W Revision A.13.00
Page Up
If the signal list fills more than one page, pressing this key moves the signal list up by one page.
Key Path
Meas Setup, Signal List, Navigate
Notes Front panel only.
Couplings Page Up
Initial S/W Revision A.13.00
Page Down
If the signal list fills more than one page, pressing this key moves the signal list down by one page.
Key Path
Meas Setup, Signal List, Navigate
Notes Front panel only.
Couplings Page Up
Status Bits/OPC
Dependencies
Page Down
Initial S/W Revision A.13.00
Scroll Left
Scroll the signal list to the left.
780 EMI Receiver Mode Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)