Keysight x-series User Reference Guide

8 Frequency Scan Measurement
Trace/ Detector
Trace/ Detector
Displays the menu keys that enable you to control the trace setting.
Key Path
Front-panel key
Notes Front panel only.
Initial S/W Revision A.07.00
Select Trace
Specifies the selected trace. The “selected trace” is the trace that other parameters under the
Trace/Detector menu will apply to.
Key Path
Trace/ Detector
Notes Front panel only. The selected trace is remembered even when not in the Trace/ Det Menu.
Preset Trace 1.
State Saved Saved in instrument state.
Initial S/W Revision A.07.00
Clear Write
In Clear Write type each trace update replaces the old data in the trace with new data. When Clear Write
is pressed for one trace, the data for that trace will be cleared.
Key Path
Trace/Detector
Example TRAC:FSC:TYPE WRIT
Dependencies This key is grayed out when a scan sequence is running except during single range scanning. If the
grayed out key is pressed, an advisory message is generated. If the equivalent SCPI command is sent,
this same message is generated as part of a “–221, Settings conflict” warning.
Couplings Whenever you press Clear Write or send the equivalent remote command,
Update is set to On and Display is set to On.
Preset After a Preset, any trace that is in Trace Average is cleared (all trace points set to mintracevalue).
State Saved Saved in instrument state.
Initial S/W Revision A.07.00
Trace Average
In Trace Average type the analyzer maintains and displays an average trace, which represents the
cumulative average on a point-by-point basis of the new trace data and previous averaged trace data.
578 EMI Receiver Mode Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)