Keysight x-series User Reference Guide

5 Mode Functions
Mode
Noise Figure
The Noise Figure mode provides pre-configured measurements for making general purpose
measurements of device noise figure.
If you are using the Help feature, this mode must be currently active to access its detailed information. If it
is not active, exit the Help feature (Esc key), select the mode, and re-access Help.
Key Path
Mode
Example INST:SEL NFIGURE
INST:NSEL 219
Initial S/W Revision Prior to A.02.00
Analog Demod
Selects the Analog Demod mode for making measurements of AM, FM and phase modulated signals.
If you are using the Help feature, this mode must be currently active to access its detailed information. If it
is not active, exit the Help feature (Esc key), select the mode, and re-access Help.
Key Path
Mode
Example INST:SEL ADEMOD
INST:NSEL 234
Initial S/W Revision Prior to A.02.00
SCPI Language Compatibility
The SCPI Language Compatibility mode provides remote language compatibility for SCPI-based
instruments, such as the Rohde and Schwartz FSP and related series of spectrum analyzers.
After changing into or out of this mode, allow a 1 second delay before sending any subsequent commands.
If you are using the Help feature, this mode must be currently active to access its detailed information. If it
is not active, exit the Help feature (Esc key), select the mode, and re-access Help.
Key Path
Mode
Example INST:SEL SCPILC
Or
INST:NSEL 270
Initial S/W Revision A.06.00
226 EMI Receiver Mode Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)