Commissioning
5-23
L
EDSVS9332P-C EN 3.0
5.9.2 Load parameter set from the controller
The operating menu (Fig. 5-17) enables the parameter set to be loaded
•
from the controller to the PC by ”Read current parameter set from the controller (F7)”
– C0002 offers the following options in the menu ”Parameter set management”:
1. Loading of the default setting (C0002=0)
2. Loading of customer-specific parameter set (C0002=1)
Tip!
The RDY message is not displayed while the parameter set is loaded since the controller cannot be
operated then.
To Next Page
Loading...
