Configuration
7-17
L
EDSVS9332P-D21 EN 3.0
7.3.3 Input and outputof the STATE-BUS
Configure input and output of the FB STATE-BUS.
(E 7-267)
Change assignment:
1234
Fig. 7-9 Dialog box “Terminal I/O (digital)”
Field
Command Function
Initiate parameter menu
Click on “Dialog terminal I/O (digital)”
menu.
1 Displays whether the output X5/ ST is triggered with HIGH (1) or LOW (0) edge.
2 Displays whether the input X5/ST i s triggered with a HIGH (1) or LOW (0) edge.
3 Click on field. A window displays the available links by means of which the outgoing bus signal i s to be
output at terminal X5/ST.
•
Select link.
4 Click on field. A window displays the existing links by means of which the incoming bus signal is to be
processed.
•
Select link.
Tip!
In the “Dialog signal configuration” menu you can carry out all links to the FB STATE-BUS.
(E 7-13)
Field 4 displays these links.
To Next Page
Loading...
