Configuration
7-7
L
EDSVS9332P-D21 EN 3.0
7.2.5 Connection of function blocks
General rules
•
Assign a signal source to an input.
•
One input can have only one signal source.
•
Inputs of different function blocks can have the same signal source.
•
Only the same types of signals can be connected. Thus, the analog output signal of one
function block can only be connected to the analog input of the other function block.
Stop!
Existing connections which are not required must be removed by reconfiguration. Otherwise the
drive cannot perform the desired function.
AND1
&
AND1--IN1
AND1--IN2
AND1--IN3
AND1--OUT
C0821/1
C0821/2
C0821/3
C0820/1
C0820/2
C0820/3
OR1
|1
OR1--IN1
OR1--IN2
OR1--IN3
OR1--OUT
C0831/1
C0831/2
C0831/3
C0830/1
C0830/2
C0830/3
NOT1
1
NOT1--OUT
NOT1--IN
C0841
NOT2
1
NOT2--OUT
NOT2--IN
C0843
C0840
C0842
t
0
DIGDEL1--IN
C0724
DIGDEL1--OUT
DIGDEL1
C0721
C0720
C0723
Connection is not possible
Connection is possible
X
Fig. 7-2 Correct connection of function blocks
To Next Page
Loading...
