Configuration
7-319
L
EDSVS9332P-D21 EN 3.0
7.7 Parameter setting
•
The parameter setting of the controller is used to adapt the drive to your applications.
•
The complete parameter set is organised in codes which are consecutively numbered and
begin with ”C” (see “Code table”).
•
Save the parameter set for your application.
– The parameters are factory-set when delivered.
7.7.1 Possible parameter settings
Parameter setting with Global Drive Control
With Global Drive Control (GDC), LENZE offers an easy-to-understand tool for parameter setting.
Detailed information about parameter setting can be found in the GDC Manuals.
Tip!
Lenze recommends you to use Global Drive Control for the parameter setting of your controller.
Parameter setting with 9371BB keypad
The keypad can be used for minor changes in the parameter set.
You can also use the keypad to
•
display operating data,
•
transfer parameter sets to other controllers,
•
control the controller (e. g. controller inhibit and controller enable).
Detailed information can be found in the Operating Instructions for the keypad.
Parameter setting via bus system
Detailed information can be found in the Operating Instructions for the corresponding fieldbus
module.
To Next Page
Loading...
