Configuration
7-2
L
EDSVS9332P-D21 EN 3.0
7.1.1 Changing the basic configuration
If the basic configuration must be changed for a special application, proceed as follows:
1. Select a basic configuration via C0005 which largely meets the requirements.
2. Add functions by:
– Reconfigure inputs and/or outputs.
– Set parameters for function blocks. (
E 7-5
)
– Integrate or remove function blocks. (
E 7-11
)
Tip!
If you change the signal flow of the basic configuration, e. g. by adding function blocks, C0005 is set
to 0. The display indicates ”COMMON”.
To Next Page
Loading...
