Function library
7-228
L
EDSVS9332P-D21 EN 3.0
7.5.63 Motor potentiometer (MPOT)
Purpose
The FB replaces a hardware motor potentiometer.
The motor potentiometer is used as an alternative setpoint source, which is controlled via two
terminals.
MPOT1
Fig. 7-176 Motor potentiometer (MPOT1)
Signal
Source Note
Name Type DIS DIS format CFG List Lenze
MPOT1-UP d C0269/1 bin C0267/1 2 1000 -
MPOT1-INACT d C0269/3 bin C0268 2 1000 -
MPOT1-DOWN d C0269/2 bin C0267/2 2 1000 -
MPOT1-OUT a - - - - -
Function
Control of the motor potentiometer:
•
MPOT1-UP = HIGH
– The motor potentiometer approaches its upper limit value.
•
MPOT1-DOWN = HIGH
– The motor potentiometer approaches its lower limit value.
•
MPOT1-UP = LOW and MPOT1-DOWN = LOW or
MPOT1-UP = HIGH and MPOT1-DOWN = HIGH:
– The motor potentiometer does not change the output signal.
To Next Page
Loading...
