Lenze 9300 - Basic cam data

Commissioning
5-4
L
EDSVS9332P-C EN 3.0
5.3 Commissioning sequence
Switch on
controller
Chapter 5.4
Parameter set
already generated?
Switch on PC,
start GDC
Chapter5.5
Generate
parameter set
Chapter 5.6
Program control
Chapter 5 .10.4
Adapt controller to the
mains
Chapter 5.6.1
Adapt controller to the
motor
Chapter 5.6.2
Enter machine
parameters
Chapter 5.6.3
Enter parameters for
traversing profile
Chapter 5.8.1.3
Load
parameter set
Chapter 5.9
yes
no
A positioning already used
is to be set up again
A new positioning
is to be entered
Manual homing
Chapter 5 .10.3
Manual control
Chapter 5.7
Manual control
Chapter 5.7
Fig. 5-2 Commissioning sequence
Show/Hide Bookmarks