Commissioning
5-8
L
EDSVS9332P-C EN 3.0
5.6.2 Adapt controller to the motor
To achieve an optimum speed-torque characteristic for the drive, it is necessary to enter the
nameplate data of the connected motor.
When you use a Lenze motor:
Field Command Function
2 Click on field ”motor type (A)”. Select connected motor.
3 Click on field ”encoder (B)”. Selected feedback system used.
4 Click on field ”position polarity”. Select direction of rotation.
For motors with a resolver, use the eight-digit designation of the motor nameplate ”encoder” (as an
option).
•
For this, change to the parameter menu (see button Fig. 5-4) and select the menu
”Motor/feedback system”.
Parameter menu
Motor/Feedback systems
Motor adjustment
Feedback systems
Fig. 5-4 How to find the menus ”Motor setting” and ”Feedback systems”
In the menu ”Feedback systems”:
Field Command Function
Select C0416 Resolver error. Enter the value of the motor nameplate.
Select C0003 Save data (C0003 = 1).
If you use a motor other than the Lenze motor:
Change to the menu ”Motor setting” (see Fig. 5-4).
In the menu ”Motor setting”:
Field Command Function
Select C0086 Select a motor the data of which largely correspond to the data of the motor used.
List of the available motors: E 7-406.
Select C0006 Operating mode of the motor control
Select C0022 Adapt I
max
to the maximum motor current.
Select C0081 Rated motor power
Select C0084 Stator resistance of the motor
(only for very high demands on the control characteristics).
Select C0085 Leakage inductance of the motor
(only for very high demands on the control characteristics).
Select C0087 Rated motor speed.
Select C0088 Rated motor current.
Select C0089 Rated motor frequency
Select C0090 Rated motor voltage.
Select C0091 Motor cos ϕ.
Select C0003 Save data (C0003 = 1).
To Next Page
Loading...
