Troubleshooting and fault elimination
Reset of fault messages
8-10
L
EDSVS9332P-E EN 3.0
8.4 Reset of fault messages
Reaction to failure Re-commissioning measures Danger notes
TRIP/ FAIL-QSP
•
After fault elimination, an acknowledgement is required to restart the drive.
•
Acknowledge TRIP / FAIL-QSP as follows:
– Global Drive Control: Click the ”TRIP reset” button in the ”Diagnostics 9300”
dialog box.
E 8-4, (“Working with the history buffer”)
–KeypadXT:
Press STOP key. Then press RUN to e nable the controller again.
– Fieldbus module: Set C0043 = 0
– Control word C0135
– Terminal X5/E5 (default setting) or “DCTRL-TRIP-RESET”
– Control word AIF
– Control word system bus (CAN)
If a TRIP source is still active, TRIP cannot be reset .
Message
•
After fault elimination, the message will be reset automatically.
The drive restarts automatically if the message is
removed.
Warning
•
After fault elimination, the warning will be reset automatically.
To Next Page
Loading...
