Function library
7-88
L
EDSVS9332P-D21 EN 3.0
7.5.13.13 Prg. fct. “Repetition function - No. of pieces”
Purpose
•
Repeated repetition of the same PS or PS sequence.
9300POS015
I n c r e m e n t a c t . p i e c e c o u n t e r
o f t h e P S b y o n e
N o . o f p i e c e s
V T P C S - N o r e a c h e d ?
N
Y
R e s e t p i e c e c o u n t e r t o 0
P S
V T P C S - I N 1
V T P C S
C 1 3 5 6 / 1
C 1 3 5 7 / 1
V T P C S - I N 2
C 1 3 5 6 / 2
C 1 3 5 7 / 2
V T P C S - I N 3
C 1 3 5 6 / 3
C 1 3 5 7 / 3
V T P C S - I N 4
C 1 3 5 6 / 4
C 1 3 5 7 / 4
C 1 3 0 4 / 1
V T P C S - O U T 1
C 1 3 0 4 / 2
V T P C S - O U T 2
C 1 3 0 4 / 3
V T P C S - O U T 3
C 1 3 0 4 / 4
V T P C S - O U T 4
C 1 3 0 4 / 5
. . .
C 1 3 0 4 / 3 0
V T P C S - N o 1
V T P C S - N o 2
V T P C S - N o 3
V T P C S - N o 4
V T P C S - N o 5
V T P C S - N o 3 0
V T P C S - N o 3 1
V T P C S - N o 3 2
V T P C S - N o 3 3
V T P C S - N o 3 4
C 1 3 8 6 / x
. . .
V T P C S
Fig. 7-44 Scheme - No. of pieces - Repetition function
Function
•
Selection of a no. of pieces from VTPCS under C1328/x.
•
Selection of the PS to be branched to as long as the no. of pieces is not reached under
C1229/x.
•
Each PS has its own piece counter. C1299/x indicates the current count.
•
With every PS cycle the corresponding piece counter is increased by 1, starting from 0.
Afterwards the setpoint and actual values are compared and branched accordingly, if the
required no. of pieces has still not been reached. When the no. of pieces is reached, the piece
counter is reset for the cycle and the piece number repetition function is terminated.
•
“Program reset” resets all piece counters.
•
GDC input: Dialog “Programming”
•
Default setting: not active
To Next Page
Loading...
