Commissioning
5-28
L
EDSVS9332P-C EN 3.0
5.11 Automatic control parameter identification
The function “Automatic control parameter identification” serves to
•
identify mechanical distance parameters by a short motion run and
•
automatically set the speed and position encoder based on the parameters identified or
selected.
Stop!
•
An identification can only be carried out if the drive is not exposed to external torques. In the
event of overhauling loads (or similar) a motion must not be activated through the function!
•
Release the brake (if mounted) before executing this function.
•
Ensure the following to keep the number of revolutions:
– Brake resistor or regenerative power supply unit
– Constant moment of inertia.
•
If the values differ too much from default setting of codes C1182 - C1185, deviations in the
identification of distance parameters and thus controller setting may occur.
•
The motion to be carried out by the function must be set in a way that even the slowest
rotating element of the controller train is still moving significantly.
To Next Page
Loading...
